The best way to Install a Raise Rod in a Bathroom Sink

Pop-up stoppers have become important add-ons for bathroom sinks, however they they do not usually function the way they should, occasionally remaining completely or partly open, so the sink does not hold water. The issue might be sediment in the drain, but it is also usually the lever that controls the stopper as well as a free relationship involving the lift rod. Installing the raise rod, which typically goes straight behind the spout, is not hard, but-don’t count on on your fingers. You must be in a position to see that which you are doing, to do it correctly, and pliers are needed by you also.

Drop the raise rod to the hole supporting the faucet spout. Provided that there is nothing in the way, it’s going to drop down most of the way.

Crawl underneath the sink using a flash-light and find the lever in the pop-up stopper.

Pull back on the lever and have somebody hold the stopper open while you improve the the lever. You will sense resistance in the event the lever is correctly linked. If not, unscrew the nut and take it off. Rotate the stopper and re-insert the lever to the hook on the underside of the rod connected to it. Replace the nut.

Attach the steel plate with regularly spaced holes that included the pop up assembly, known as the clevis, in a spot near its middle to the lift rod by tightening the screw on its finish onto the rod. The screw needs to be limited enough to support the the clevis, but loose enough in order to slide changes to be made by it.

Lift up the lever as far as it is going to go, then insert the conclusion to the closest hole on the clevis, sliding the clevis down or up the rod as required to do this. Slide the clevis about 2″ over the lever, then secure it using a spring clip, a ushaped piece of steel with two holes. Squeeze the clip, slide it on the lever and launch it.

Tighten the nut keeping the clevis to the raise rod using a pair of pliers. It is developed to be hand-tightened, but recurring procedure of the stopper may cause make it to slip unless you’ve got fingers that were unusually robust.

Confirm the stopper opens and lift the rod reduce it, fill the sink and permit the water stand. Unscrew the nut in the event the sink drains and improve the the clevis 1/4

See related